As of September 25, 2026, the Yipin Air Fryer Cleaner is on the shelf, with a specification of 500g and a liquid formulation.
The first step in the cleaning sequence is not spraying, but turning off the power and allowing it to cool. The product page for EPHYON requires unplugging the device before cleaning; maintenance materials for Philips, Ninja, Instant Pot, Hamilton Beach, and COSORI devices also emphasize turning off the power and waiting for the device to cool. The specific cooling time and detachable structures should be based on the manual for the model of air fryer you have.
The main unit and detachable parts must be handled separately. Both Ninja and Instant Pot remind users not to immerse the main unit in water, while Hamilton Beach recommends cleaning the device's surface with a soft, damp cloth and treating detachable parts such as the pot and frying basket according to the methods allowed in the manual. General information can only support the principle of 'distinguish the parts first' and cannot replace the instructions for specific models.
The instructions for using the EPHYON product are: Spray it while keeping a distance of more than 10 cm from the surface to be cleaned, then wipe with a cloth or sponge, and then rinse with clean water and air dry. This set of steps applies to removable surfaces that the device manual allows to be contacted and rinsed; the liquid should not be sprayed directly into the main unit, vents, heating elements, electrical areas, or other non-rinsable structures.
Cleaning tools also have limits. Philips, Instant Pot, and Hamilton Beach all remind users to use soft or non-abrasive tools and to avoid metal or rough materials that may damage the coating. The product itself and the cleaning action are two different things: even if the cleaner is safe to use, excessive rubbing may still damage non-stick surfaces, so priority should be given to using sponges, soft cloths, or soft brushes as recommended by the device manual.
Material restrictions need to be checked item by item. The top-quality clean page clearly indicates that this product is not suitable for aluminum products; painted surfaces should first be tested in an inconspicuous area; it should also not be used on surfaces that are not alkali-resistant. Consumers cannot determine material compatibility solely based on the category name 'air fryer,' because the same device may contain coated metal, bare metal, plastic, electrical components, and sealing materials at the same time.
Rinsing and drying are an operational closed loop. The product page requires rinsing with clean water and then air drying, and the instructions of Ninja and Hamilton Beach also emphasize that detachable parts should be thoroughly dried after cleaning. If the device manual prohibits a certain part from being rinsed directly, the cleaning method requiring rinsing should be discontinued and replaced with the method allowed by the manual, rather than leaving cleaning agents in areas that cannot be rinsed.
An executable checklist is: confirm the model manual; unplug the power and allow it to cool completely; identify the main unit and removable parts; check aluminum, paint, coating, and alkali-sensitive surfaces; first observe in a concealed area; spray at a distance according to the page onto surfaces that are allowed to be treated; wipe with a soft tool; rinse and dry thoroughly as permitted by the manual; reconfirm there is no residual liquid before resetting everything.
The exact ingredients, dosages, warnings, prohibited materials, and applicable users shall ultimately be based on the current complete product label in hand, the equipment manufacturer's instructions, and the applicable regulations; if any item is unclear, use should be stopped and verified with the product or equipment manufacturer first.
