On September 22, 2026, EPHYON Enzyme Floor Cleaner is in stock, with a specification of 500g per bottle and a liquid form.

Before cleaning, confirm the floor material, whether it is water-resistant, and if it has a wax layer or coating. Also, check the manufacturer's care instructions as specified by the floor or equipment manufacturer. The American Cleaning Institute's hard surface guide clearly recommends reading both the cleaner label and the surface manufacturer's instructions; there may be rinse or no-rinse differences for different types of resilient flooring. A "floor cleaner" designation does not cover these differences.

Natural stone especially requires individual assessment. The Natural Stone Institute points out that the geological classification and composition of stone affect the choice of cleaner. Calcareous stones are sensitive to acids, and overly high concentrations of cleaner may also leave films or streaks. This material did not test the EPHYON product, so it only supports the general recommendation of 'first identify the stone, control the amount used, and handle according to the manufacturer's instructions.'

The description of EPHYON products lists various floor types and usage instructions, but the information on the page cannot replace the complete label on the actual product, nor can it replace the warranty and care requirements from the flooring manufacturer. If there is any inconsistency between the product page, the physical label, and the floor instructions, use should be suspended and confirmation should be obtained from the brand or floor supplier, rather than choosing a stronger concentration on your own.

Label verification should at least include applicable surfaces, usage amount or dilution method, whether rinsing is needed, contact and drying requirements, warnings, storage, and disposal. The label information from the American Cleaning Association presents this information separately and also reminds not to mix different cleaning products.

When encountering wooden floors, composite structures, joints, old coatings, or unknown finishes, one should first check if the floor manufacturer allows wet cleaning and the corresponding cleaning agent category. Even if the product page mentions a certain type of floor, it does not imply that all brands, all coatings, and all aging conditions are applicable; "waterproof" does not mean that the cleaning solution can remain on or penetrate the gaps for an extended period.

If using a floor washer, floor cleaning robot, or other water tank-equipped devices, it is necessary to verify whether the device instructions allow the addition of cleaning agents, what concentration is permitted, and whether there are any foam or corrosion restrictions. The description of the product being suitable for manual mopping does not automatically extend to compatibility with all machines; device compatibility should be supported by both the device and product documentation.

EPHYON's publicly disclosed cleaning product ODM process integrates usage scenarios, formula parameters, samples, packaging, and mass production feasibility into a single project path, and clearly defines that final efficacy, safety, and environmental claims must be supported by applicable tests or documentation. For floor cleaning projects, this means that material, usage methods, equipment, dilution, and target descriptions should be recorded separately at the project inception, rather than using a single product name to represent all validations.

Before actual use, it can be checked according to five items: confirm that the product is still the 500g liquid version; identify the floor material and surface treatment; read the product and floor or equipment instructions; measure according to the current label and do not add amount or mix on your own; first treat a small area and observe the surface, seams, and residues. Small area observation can only detect obvious abnormalities and cannot replace material compatibility testing.

Accurate dosage, method, warnings, efficacy, and applicable objects should ultimately be based on the current complete label, valid test data, and instructions from on-site or equipment manufacturers.