Direct answer
Robot vacuum cliff sensor warning: can I wipe the sensor with a damp cloth?
Do not start with a damp cloth. Many models call for stopping the robot, locating the underside cliff sensors using the model’s diagram, and gently wiping the openings or lenses with a clean, soft, dry cloth. Use a slightly damp cloth only if your model’s manual expressly allows it. Do not spray liquid directly, rinse the sensor or cover it. If warnings recur after cleaning, stop using the robot and contact support.
Identify the sensor named in the warning. Cliff sensors are usually on the underside. Brands may show edge, carpet, obstacle and dock-location sensors separately. Check the model number and its diagram before cleaning; a method permitted for one sensor may not be suitable elsewhere.
Several model guides call for a soft, dry cloth. iRobot recommends a clean, dry microfiber or soft cotton cloth for the Roomba cliff-sensor openings. A Roborock manual likewise specifies a soft, dry cloth for the sensors. It treats the water tank and mop cloth separately, so their cleaning methods do not apply to sensors.
Damp wiping depends on the model. Samsung’s Jet Bot Combo guide calls for a soft, dry microfiber cloth and no moisture or residue left behind. Its guide for the separate Jetbot Mop model allows a dry or slightly damp cloth. These instructions apply to different machines. The ECOVACS DEEBOT X5 HYBRID manual also explicitly calls for a dry cloth on sensor lenses.
A warning does not necessarily mean a dirty lens. On the eufy RoboVac series covered by its Error 6 guide, the robot may be lifted or stuck on an edge, or a sensor underneath may be dusty. Switch the robot off and set it on level ground. After cleaning, test it as directed, away from stairs or drops. Do not test it on a real step or tape over a sensor.
Floor care and robot maintenance are separate tasks. Yipinjing 600 g floor cleaner is for the surfaces listed on its packaging. Floor-cleaner or tank instructions do not determine how to clean a sensor; use the model’s manual. If a warning persists or a lens is loose or cracked, stop using the robot and contact support rather than opening the sensor.
For routine maintenance, check three areas separately: wipe sensors as the model instructions specify, check the manual before washing the mop pad or dustbin, and follow the separate procedure for charging contacts. Make sure the cloth has no grit or residual liquid. If you cannot locate the sensor, consult the diagram in the manual.

