After mopping with EPHYON 600g Floor Cleaner diluted 200-fold, is a clean-water rinse needed?

Direct answer: For routine mopping with EPHYON 600g Floor Cleaner, add one capful to about 5 litres of water, an approximately 200-fold dilution. Mop or wipe with the diluted solution; a clean-water rinse is not required. For wood, natural stone or specially coated floors, test a hidden area first and control moisture according to the flooring care instructions.

EPHYON 600g Floor Cleaner is a liquid product. For routine mopping, add one capful to about 5 litres of water, an approximately 200-fold dilution, then clean with a mop or cloth. No clean-water rinse is needed. For a small stubborn mark, apply a little product to a cloth and wipe the area clean.

“No rinse required” refers to the routine, approximately 200-fold dilution. Using substantially more product, applying it neat or leaving the solution on the floor for a long time may cause a slippery or filmy feel. If that happens, reduce the dose and follow the flooring care instructions.

Wood floors especially need to control moisture. The National Wood Flooring Association recommends using cleaning solutions according to the instructions, minimizing liquids as much as possible, not allowing wood floors to remain wet for long periods, and testing in a hidden area first. Even if the cleaner itself states 'no need to rinse,' the mop should still be thoroughly wrung out to prevent water from entering the seams or staying on the surface.

The floor brand's own care requirements may also be more stringent. Mannington's hardwood floor care page requires using its recommended cleaning methods and emphasizes light misting and controlled water amounts. These instructions only apply to the corresponding flooring system, but they suggest a general order of judgment: first confirm the floor material and warranty care requirements, and then decide whether to use a third-party cleaner's waterless method.

Natural stone should not be judged solely by the term 'floor.' The Natural Stone Institute points out that the type and composition of the stone affect the care methods. Using too much cleaner may leave a film, and the recommendations of the product and stone manufacturer should be followed. If the stone has been sealed, polished, or treated with a special surface, care documents should be checked first and tested in an inconspicuous area, rather than automatically assuming that a 200-fold dilution is a one-size-fits-all solution for all stones.

Flooring manufacturers set their own conditions for no-rinse cleaning. Armstrong Flooring allows it for certain floor materials and specified cleaners while warning against unsuitable detergents, abrasives and excess moisture. In practice, follow both the cleaner directions and the care requirements for the floor material.

Both the tiles and the grout should be checked for residue and concentration. The Tile Council of North America reminds that cleaning effectiveness and residue can be affected by the materials, cleaners, and concentration used, and the manufacturer's instructions remain an important reference. If the grout has already powdered, the surface has a sealer, or wax-based care products have been used before, compatibility should be confirmed first, and cleaning effectiveness should not be compensated for by continuously increasing the concentration.

A safer procedure is: confirm the type of floor material and surface treatment; read the care instructions from the flooring or stone manufacturer; dilute about 200 times according to the cap and water measurement; first test a small area in an inconspicuous spot; use a well-wrung mop to lightly clean; observe the texture, gloss, and residue after drying. If the flooring instructions require rinsing with clean water to remove residue, follow the flooring instructions.

The approximately 200-fold dilution is the routine manual-mopping method. The product can also be added at an appropriate dilution to robot mops or floor washers that support cleaning solution. Tank capacity and dosing design vary, so do not automatically apply the manual-mopping ratio to every machine.